VW CRAFTER 2.0 TDI (17-) Lift Kit Twin-Monotube TMP-LIFT-TGE-1 - Front drive

General Notes on Eibach Suspension Systems:

• Unless otherwise stated, for vehicles that are factory-equipped with a sport suspension, the lowering / raising specified in the catalog is reduced by the amount of the factory lowering / raising. Unless otherwise stated, vehicles that are factory-equipped with a raised suspension (e.g., off-road character, crossover, or rough terrain packages) are excluded from using our products.
• Please check before installation using the certificate whether the delivered items (see part identification) are approved for your vehicle (see application area).
• We recommend that the installation of our products be carried out only by a qualified workshop that has appropriately trained personnel and the necessary special tools.
• You can "read" the installation position from the printing; install the spring so that you can read the printing. - The number must not be "upside down".
• After the installation of the spring/suspension components, a verification of the wheel alignment values is absolutely necessary.
• If the stock shock absorbers are no longer fully functional and have noticeably lost their effectiveness, we strongly recommend replacing them with new stock shock absorbers or sport shock absorbers.
• For Sportline springs, we recommend the installation of sport shock absorbers such as KONI Sport, KONI STRT, or Bilstein B8.
• All wheel/tire combinations approved by the wheel type testing authorities can be used. The requirements in the wheel certificate must be adhered to, with the exception of the demand for stock suspension.
• Depending on the engine, transmission, equipment, and tolerances of the vehicle, the lowering or raising may deviate by a few mm from the specified values. The amount of lowering or raising is always reduced by the amount of a factory lowering or raising.
• The usability of Eibach products refers to vehicles that remain stock. In the case of modifications and special equipment (this also applies to stock accessories!) such as the installation of a special braking system (e.g., ceramic brake system), wheel central locking, sport suspension, LPG system, etc., Eibach products may not be used. The specified measurements refer to stock new vehicles. Measurement points: Vertical distance from the center of the wheel hub to the lower edge of the fender. In principle, the specified measurements are target values, which may vary depending on the vehicle.